PXT30AL-M
2. Widely applicable for high-power connection scenarios between batteries, motors, and electronic control units, it serves as a stable and reliable high-current connector solution for battery connections, motor connections, and electronic control connections.
- Detail
Product Name：PXT30AL-M
I. Product overview
1. The PXT30AL-M is an 180° cable-exit, injection-moulded, straight 3-pin high-current connector. As the standard product for high current connectors in the current lithium battery industry, its design also incorporates both vertical wire-to-board and horizontal board-to board configurations.
2. Widely applicable for high power connection scenarios between batteries, motors, and electronic control units, it serves as a stable and reliable high current connector solution for battery connections, motor connections, and electronic control connections.
II. Product Performance
Electrical performance | |
Rated current (4H cycle) | 10A 18AWG 30K |
15A 16AWG 30K | |
15A 18AWG 55K | |
20A 16AWG 55K | |
20A 18AWG 85K | |
25A 16AWG 85K | |
Rated voltage/withstand voltage | 100V（DC） 1200V（DC） |
Contact resistance | ≤ 1.8mΩ |
Electrical insulation resistance | ≥ 3000MΩ |
Mechanical property | |
Insertion force of finished product | ≤ 6.5kgf |
Finished product pull-off force | ≥ 1.2kgf |
Number of insertions and removals | 500 times |
Environmental resistance | |
Scorch wire rating | GWFI 850℃ |
Flame retardant grade | UL94 V-0 |
Operating temperature | -40℃ to 125℃ |
Salt spray | 48H |
Material and use | |
Casings | PA66 Colours: Yellow, Black, Blue |
Master copper | copper alloy Gold Plated |
Eco-friendly material | RoHS 2.0 compliant |
Connection method | Soldered |
Connection parameter | Refer to the Welding Instruction Manual |
*To ensure you obtain the most accurate product data, PLSUN recommends consulting the latest product specification sheet. Should you require assistance, please do not hesitate to contact us.
III. Product View
 | |
PXT30AL-M （No rear cover） | PXT30AL-M （带后盖） |
| |
Stacked chart （No rear cover） | 堆叠图 （带后盖） |
IV. Precautions
1. Store in a clean, dry, well-ventilated warehouse, away from any corrosive gases such as acids or alkalis. It is recommended to keep the original packaging sealed. Once opened, use promptly to avoid prolonged exposure to air.
2. The storage environment temperature must be maintained between -10°C and 40°C, with relative humidity not exceeding 80%, to prevent material ageing or deterioration in performance.
3. This product must only be plugged in or unplugged when completely disconnected from the power supply. Under no circumstances should it be plugged in or unplugged while energised, as this may cause arcing, resulting in product damage or triggering a safety incident.
4. The product is suitable for transport by conventional means. During transit, avoid severe impacts and violent vibrations, and implement protective measures to prevent direct exposure to rain or snow, or water immersion.
5. When in use, the connector must be securely fastened to the main body of the equipment to prevent exposure to external impacts or sustained pulling forces. Ensure that no looseness or movement occurs after installation to guarantee the long-term stability of the electrical connection.
6. When inserting or removing connectors, ensure vertical alignment and apply even pressure. Never tilt the connectors or use excessive force. Upon correct connection, the male and female plastic housings should be fully seated with no visible gaps.